Why my variable is not defined in this scope?

8 次查看（过去 30 天）
Abdelrhman Abdelfatah
回答： Dongyue 2022-12-15
I have the following function
dq_k = [];
for i1 = 1:numel(d_k)
if (d_k(i1) <= dR(end) && d_k(i1) >= dR(end-1)) % greater than or equal to maximum interval
dqe1 = dR2(end); % use maximum interval value
else
for i2 = 1:L-1
if (d_k(i1) <= dR(end-i2)) && (d_k(i1) >= dR(end-i2-1))
dqe1 = dR2(end-i2);
end
end
end
dq_k = [dq_k dqe1];
end
everytime I run it inside my whole code
it gives me this error
Unrecognized function or variable 'dqe1'.
Error in Trial2222 (line 63)
dq_k = [dq_k dqe1];
And here are my input varaibles to this function
dR =
1.0000 2.5000 4.0000 5.5000 7.0000
dR2 =
1.7500 3.2500 4.7500 6.2500
d_k =
1.0000 1.0000 0.2500 -0.5000 -1.2500 -2.0000 -2.7500
  2 个评论
Abdelrhman Abdelfatah
Abdelrhman Abdelfatah 2022-12-11
I put its value to be 4, and I calculated the dR and dR2 based on L value as following
m_kmax= max(m_k);
m_kmin= min(m_k);
stepsize=((m_kmax-m_kmin)/L);
if tread == 1
dR =linspace(m_kmin,m_kmax,L+1);
else
dR= stepsize + linspace(m_kmin,m_kmax,L+1);
end
dR2=zeros(1,L);
for i=1:L
dR2(i) = ( dR(i) + dR(i+1)) ./ 2;
end
But what I just figured is my function attached in this comment, which was supposeded to switch Quantizier between midrise or midtread is not actually doing what it was supposed to do, that's why I am considering adjusting it.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Dongyue
Dongyue 2022-12-15
If the two conditions:
if (d_k(i1) <= dR(end) && d_k(i1) >= dR(end-1))
and
if (d_k(i1) <= dR(end-i2)) && (d_k(i1) >= dR(end-i2-1))
are both not met, dqe1 will not be created unless you set default value for it.

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by