Set position of image in matlab code PDF

4 次查看（过去 30 天）
Mia Vesterager
Mia Vesterager 2023-1-6
回答： Sulaymon Eshkabilov 2023-1-7
Hello,
I am very happy with using matlab, I use it for solving exercises which I then convert to PDF for easy access. However, when i use the command imshow("picture.jpg") a specific place in the Matlab code, the PDF always place it at the bottom of the section instead of where the code is written. Is there a way to set the position of an image in a PDF doc?
Thank you.
  3 个评论
显示 1更早的评论
Mia Vesterager
Mia Vesterager 2023-1-6
For example, when I review my PDF i would like my image to show up at the same position in the text/code as where i placed it, but right now it shows up in the bottom of all my text/code, meaning i have to go down to see the image and then back to the part of the text where it is relevant.
%% Exercise 2
% in a wye-wye connection, find the line currents, line voltages and
% the load voltages
clear all
close all
clc
imshow("lecture6_ex2.jpg")
%Because it is a 3-phase balanced circuit, we can simply make the
%calculations based on a single phase and then recover to 3-phase by using
%the phase relationship.
%The load voltages (in this case the same as phase voltages, because the
% total load of the single phase is included from point A to point N and
% the same for the rest)
V_AN=220*exp(j*deg2rad(0)); %V
V_BN=220*exp(j*deg2rad(-120)); %V
V_CN=220*exp(j*deg2rad(120)); %V
Mia Vesterager
Mia Vesterager 2023-1-6
Unfortunalty, i have been seaching a lot on the internet but have not found a solution

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sulaymon Eshkabilov
This can be achieved using %%, e.g.:
% Image is shown here after the command imshow()
imshow("MY_image.jpg")
%% Simulation results
A = magic(3);
B=A.^3
fprintf('Time: %13c \n', now)

类别

在 Help Center 和 File Exchange 中查找有关 Image Processing Toolbox 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by