I understand you want to set up the signals and phases correctly in the Scene Tool, but there might be some issues with how you are configuring the simulation. Here are some things to check:
- Make sure that you have selected the correct signal controller for your junction in the Simulation Configuration. To do this, go to the "Signal Control" tab in the Simulation Configuration window and select the signal controller that corresponds to your junction.
- Check the timing of the signal phases in the Signal Control tab. Make sure that the green, yellow, and red times are set correctly for each phase, and that the phase sequence is correct.
- Ensure that you have assigned the correct movements to each phase in the Signal Control tab. To do this, select a phase and check the "Movements" section. Each movement should correspond to a lane or group of lanes that are allowed to proceed during that phase.
- Check the "Vehicle Parameters" tab in the Simulation Configuration window to make sure that you have set the correct values for vehicle acceleration, deceleration, and maximum speed. These values can affect how vehicles approach and respond to signal changes.
If you have checked all of these settings and are still experiencing issues with the signal timings, you may need to adjust your simulation parameters or consult the RoadRunner Scenario documentation for more information on signal control.
