Solver was unable to reduce the step size without violating minimum step size of 8.8942E-18 for 1 consecutive times at time 0.0025035. Solver will continue simulation with th

66 次查看（过去 30 天）
Amrapali Gamare
Amrapali Gamare 2023-2-2
回答： Swaraj 2023-4-6
  • Solver was unable to reduce the step size without violating minimum step size of 8.8942E-18 for 1 consecutive times at time 0.0025035. Solver will continue simulation with the step size restricted to 8.8942E-18 and using an effective relative error tolerance of 0.390524, which is greater than the specified relative error tolerance of 0.001. This usually may be caused by the high stiffness of the system. Please check the system or increase the solver Number of consecutive min steps violation parameter.

请先登录，再回答此问题。

回答（1 个）

Swaraj
Swaraj 2023-4-6
Hi,
I understand that you are getting an error. I went through to understand the reason for this error.
When the solver is unable to solve the equation within the specified step-size, an error may occur.
Increasing the minimal number of consecutive steps, the model takes is one of the suggested solutions for this problem. Expanding the "Additional options" section in the solver part of the configuration settings will change this value.
A dialogue box with the title "Number of consecutive min steps:" should be visible in this part. Increase this box's value.
You can also try to relax all the tolerances in the model from the Model Configuration Parameters.
Go through the following documentation to understand in detail.
Minimum step size for variable-step solver - MATLAB (mathworks.com)
Number of minimum step size violations allowed before issuing diagnostic - MATLAB (mathworks.com)
I hope it helps.
Let me know it is not getting solved.
Thanks!!

类别

在 Help Center 和 File Exchange 中查找有关 Configure Simulation Conditions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by