How do i test my neural network with using "if statement" commands

1 次查看（过去 30 天）
Mashael Alhasan
Mashael Alhasan 2023-2-4
回答： osman alper altun 2023-2-14
I trained two fitting neural networks one with one output and the other with three outputs.
I want to test the network performance using "predict" but i also do not want the prediction to display numbers.
instead I want it to display "Good", "bad" or "average" depending on a range of values for each statement.
and for the three output network i would like it to display for example "good", if y1= good, y2=good, y3=good. "average" if y1= good y2= avreage y3=good and so on.
How can i generate "if statement" commands that will display the prediction as statement.

请先登录，再回答此问题。

回答（1 个）

osman alper altun
osman alper altun 2023-2-14
Hello,
For example, once you complete the neural network simulation you can test your results as below:
testResult = sim(net,testInputs');%Here is the testing your simulation with test inputs
After this section you can check the testResults values and create the algorithm as you want.

类别

在 Help Center 和 File Exchange 中查找有关 Deep Learning Toolbox 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by