Tuning parameter(Switching frequency) in PWM Generator (three-phase, two-level)

Question

Jia Sheng Ong 2023-3-6

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1923610-tuning-parameter-switching-frequency-in-pwm-generator-three-phase-two-level

评论： Putri Aida Natasya 2024-3-10

Hi, I am currently studying the effects of varying switching frequency towards the inverter and motor system efficiency. I am using the three-phase converter which the gate signal is sent by a PWM generator. Inside the PWM generator block, there is switching frequency parameter. Therefore, is it possible if I can tune the value of switching frequency by making it as input and receving the signal in Matlab Simulink similar with Vabc and Vdc instead of tuning from Matlab code?

Hope to receive any comment or suggestion. Thank you.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Putri Aida Natasya 2024-3-10

hi, your project is quite similar to me. if you don’t mind to share, may i know, where you learned to do this simulation or you did it by yourself?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sabin 2023-3-6

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1923610-tuning-parameter-switching-frequency-in-pwm-generator-three-phase-two-level#answer_1186390

In theory should work by defining the fsw as input rather than parameter but extra care should be taken to ensure the frequency is not changed too often and there are enough samples (at least 10 samples for a switching period, ideally around 100 samples). However, if the plan is to check the efficiency as a function of switching frequency may be better to use fast restart and run same scenario at different switching frequency. I hope this helps.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Jia Sheng Ong 2023-3-6

I see...thanks for replying. May I know how to define the fsw as input in Simulink without making it as variable in .m file? Can I use "look under the mask" function and add an extra input port as fsw?

请先登录，再进行评论。