encoder block in simulink for ESP 32
显示 更早的评论
Hi,
can you please tell me how can i read/measure the speed of motor using ESP32 in simulink by using any encoder block.
采纳的回答
aakash dewangan
2023-3-21
编辑：aakash dewangan
2023-6-19
1 个投票
更多回答（1 个）
Praharshita
2023-3-13
0 个投票
Hi Aakash,
To Read/Measure the speed of motor using ESP32 in simulink by using any encooder block,
- Open a new Simulink model and add an Arduino block from the Simulink Library Browser.
- Double-click on the Arduino block and select the ESP32 board from the list of supported Arduino hardware.
- Add an Encoder block from the Simulink Library Browser and connect its output to a scope block.
- Configure the Encoder block by specifying the pin number for the encoder signal input and the encoder resolution in pulses per revolution.
- Set the simulation stop time and other simulation parameters as desired.
- Run the simulation and observe the output of the scope block to see the speed of the motor in revolutions per minute (RPM).
Hope these steps help resolve the issue.
类别
在 帮助中心 和 File Exchange 中查找有关 Arduino Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
