Parallel Computing Toolbox and parsim: two different versions of Matlab?

1 次查看(过去 30 天)
Hello everyone,
I installed Parallel Computing Toolbox on my Matlab 2014a in order to run multiple Simulink runs but discovered that probably parsim command is not identified on my release.
According to system requirements, Parallel Computing Toolbox has been introduced on Matlab 2008 but parsim is identified from Matlab 2017 version.
Is this possible? Is there a workaround to run multiple simulation on Matlab 2014 without using parsim?

回答(1 个)

Raymond Norris
Raymond Norris 2023-3-24
Consider using parfor and sim, but read this first

类别

Help CenterFile Exchange 中查找有关 Run Multiple Simulations 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by