why am i getting this error with activation function in my code

Question

Reesha deevina Lobo 2023-3-29

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1937074-why-am-i-getting-this-error-with-activation-function-in-my-code

回答： Jack 2023-3-29

layers = [fullyConnectedLayer(num_neurons, 'ActivationFunction', activation_function) fullyConnectedLayer(1, 'ActivationFunction', 'purelin')];

i am getting this error

Error using fullyConnectedLayer

layers = [fullyConnectedLayer(num_neurons, 'ActivationFunction', activation_function) fullyConnectedLayer(1, 'ActivationFunction', 'purelin')];

Invalid argument name 'ActivationFunction'. Name must be one of these:

'Name'

'WeightLearnRateFactor'

'BiasLearnRateFactor'

'WeightsInitializer'

'BiasInitializer'

'WeightL2Factor'

'BiasL2Factor'

'Weights'

'Bias'

Error in ann (line 14)

layers = [fullyConnectedLayer(num_neurons, 'ActivationFunction', activation_function) fullyConnectedLayer(1, 'ActivationFunction', 'purelin')];

>> ann

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jack 2023-3-29

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1937074-why-am-i-getting-this-error-with-activation-function-in-my-code#answer_1203274

在 MATLAB Online 中打开

Hi,

The error message suggests that the argument 'ActivationFunction' is not a valid argument for the fullyConnectedLayer function.

In recent versions of MATLAB (R2020b and later), the ActivationFunction argument has been replaced with Activation. Therefore, the correct syntax to specify the activation function for a fully connected layer in these versions would be:

layers = [fullyConnectedLayer(num_neurons, 'Activation', activation_function)fullyConnectedLayer(1, 'Activation', 'linear')];

Note that the 'purelin' activation function has been replaced with 'linear'.

If you are using an older version of MATLAB, you can try removing the 'ActivationFunction' argument and use the default activation function ('relu'):

layers = [fullyConnectedLayer(num_neurons)fullyConnectedLayer(1, 'ActivationFunction', 'purelin')];

Alternatively, you can specify the activation function using the 'Name' argument, like this:

layers = [fullyConnectedLayer(num_neurons, 'Name', 'fc1', 'ActivationFunction', activation_function) fullyConnectedLayer(1, 'Name', 'output', 'ActivationFunction', 'purelin')];