I am getting an error 'Output Port 1' of 'Wind_Turb​ine/Scopes​/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output

2 次查看（过去 30 天）
Karam Karas
Karam Karas 2023-4-7
回答： Dimitri MANKOV 2023-4-11
I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output ?

请先登录，再回答此问题。

采纳的回答

Dimitri MANKOV
Dimitri MANKOV 2023-4-11
Hi Karam,
It looks like these output ports are not used anywhere in your model, so you can simply delete them to get rid of the warning message.
I hope this is helpful!
Dimitri

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Model, Block, and Port Callbacks 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by