In Simscape: How to change runtime of simulation and how to change name of blocks?

6 次查看（过去 30 天）
DB
DB 2023-4-24
评论： DB 2023-5-8
1) I change the runtime from 1-1000, but the Results Explorer still just runs it for the default 10 seconds. How do I fix this? I already tried increasing timescale of plot, but it didn't run longer than 10 seconds.
2) I named a block "Pre Tank (IL)", but in the results explorer it's just named "Tank". How do I change this?

请先登录，再回答此问题。

采纳的回答

Piyush Dubey
Piyush Dubey 2023-5-3
编辑：Piyush Dubey 2023-5-3
Hi,
1) The run time of the simulation model can be changed from the Simulation tab, under Simulate section. There the stop time can be changed which determines till what time should the simulation run.
Details for which can be obtained in the following documentation: https://www.mathworks.com/help/simulink/gui/stoptime.html
2) Any changes in the name of block gets reflected throughout the model once the simulation has re-run with the new set of changes. Ensure that you have run the simulation model again after making necessary changes.
Re-running the model with the changes will reflect the changes throughout over the axes as well as the name of the block inside the results explorer.
Hope this helps!
  1 个评论
DB
DB 2023-5-8
Thank you, but that was what I already did before asking. It seems that there was an error and it was resolved by restarting my computer.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Creating Custom Components and Libraries 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by