How to open Scope in Simulink with Matlab command?

53 次查看（过去 30 天）
Mahdiyar
Mahdiyar 2015-4-2
编辑： carlos vasquez 2017-1-31
Hi everyone
I want to run the simulink with the matlab command "sim". I need to see the trend of a signal . So, I use a Scope.
I want to open the scope with a matlab command line. Is there any way to open the scope in simulink with matlab command, not manually?
Regards

请先登录，再回答此问题。

采纳的回答

Azzi Abdelmalek
Azzi Abdelmalek 2015-4-2
open_system('YourSimulinkModelName/ScopeName')
  2 个评论
carlos vasquez
carlos vasquez 2017-1-31
编辑：carlos vasquez 2017-1-31
i use this comand but, when i want to use the command set_param(gsc,'Simulationcommand','Stop'). i have this error. subsystem block does not have a parameter named 'Simulationcommand'. also i use the comand close_param for close all but i have the same error. this command works on guide of matlab?
help

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by