Instrument control toolbox does not support Keysight CXG generator?

Question

Edward Kornegay 2023-5-5

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1958624-instrument-control-toolbox-does-not-support-keysight-cxg-generator

回答： Atharva 2023-6-22

I see every other high-end generator listed as being supported. The CXG is the bottom end of a top-end product. Hard to believe it is not supported. Is this because of something fundamental or can I work around it? Or is it wrong and it is supported, just documentation is out of date?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Atharva 2023-6-22

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1958624-instrument-control-toolbox-does-not-support-keysight-cxg-generator#answer_1260589

Hey Edward,

According to the official documentation of the Instrument Control Toolbox, Keysight CXG generator is not explicitly mentioned as a supported instrument.

However, this does not necessarily mean that it is not possible to control your Keysight CXG Generator using the toolbox. The Instrument Control Toolbox supports communication with instruments that follow a standard communication protocol such as GPIB, VISA, or TCP/IP.

Therefore, if your Keysight CXG Generator supports any of these communication protocols, you can use the toolbox to communicate with it. You may need to manually configure the communication settings and command syntax specific to your generator.