How to set time domain Simscape model to hours instead of seconds?

2 次查看（过去 30 天）
DB
DB 2023-5-15
回答： DB 2023-5-16
For my hydraulic isothermic model I model a centrifugal pump installation. Normally, flows and pump capacity characteristics are in m^3/h. However, in the centrifugal pump (IL) block I need to set capacity vector in m^3/s, and it does not recognize me changing it to m^3/h. This makes it more difficult than necessary, as I now need to change all other flow units to m^3/s. I cannot just act like seconds are hours, as I will then get problems with units as rpm (minute).
How do I change the flow to m^3/h?

请先登录，再回答此问题。

采纳的回答

DB
DB 2023-5-16
It seems the notation for hours is hr, not h. Therefore, I can change the flowrate from m^3/s to m^3/hr and it works.

更多回答（1 个）

Nikhil Muthakana
Nikhil Muthakana 2023-5-15
Convert your m^3/h parameters to m^3/s by dividing the m^3/h value by 3600 (since 1 m^3/s = 3600 m^3/h)
  3 个评论
显示 1更早的评论
Nikhil Muthakana
Nikhil Muthakana 2023-5-15
The blocks do not have the option of m^3/h (even in the Flow Rate Sensor block), so after converting the simscape physical signals to simulink data signals, use a gain block on the signal with 3600 as the value to convert the m^3/s to m^3/h when you log the flow rate signals. You can name the signals appropriately to keep track of the units.
DB
DB 2023-5-16
It seems the notation for hours is hr, not h. Therefore, I can change the flowrate from m^3/s to m^3/hr and it works.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Upgrading Hydraulic Models to Use Isothermal Liquid Blocks 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by