Control System Designer app error
2 次查看(过去 30 天)
显示 更早的评论
I want to tune couple of gain in my simulink model. After I choose the relevant blocks to tune I want to see the nichols of the open loop so I used LoopTransfer opening.
But I dont get (in the response section in the app) the ss variable of the linearization. when I tried to add the LoopTransfer opening location manually I get the following error:
"The selection location is defined as parmenent opening in the architecture. Remove this opening to create a request to this location"
I dont get this error. I tried to delete the LoopTransfer opening in my model, but I still get this error.
In addition I have one more quastion:
when I need to choose the signal for the lineariztion openning, The app have 2 section to specify:
- "Specify the open-loop response at the following locations"
- " Compute open looop response with the following loops open"
I don't understand the diffrent between this two. where do I need to specify the LoopTransfer opening for the linearization? when I will want to use both of this sections?
Thank you!
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Classical Control Design 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!