I have a question about the connection of PV arrays in series and how it works

2 次查看（过去 30 天）
Martin Viktor Mannes
回答： Kothuri 2024-2-15
The problem is that, when I connect two PV arrays in series with both 10 modules and the same data like in the picture it doesn't work, but when I use one pv array with 20 modules it works. I don't get why this does not work, because I want to work with partial shading. The problem is that the simulation starts, but immediately stops.

请先登录，再回答此问题。

回答（1 个）

Kothuri
Kothuri 2024-2-15
Hi Martin Viktor Mannes,
I understand that the simulation stops immediately when two PV arrays with 10 modules each are connected in series. But when I ran the simulation by connecting two PV arrays with 10 modules each in series connected to a resistive load, the simulation ran successfully.
I tried to reproduce the error, but I was not able to as the details of solver and the load was not provided, but if you still get error after following mentioned workflow, share these details.
I am attaching the snapshots of the Simulink model which I have tried and its output.
You may refer the below link which shows a Simulink example on Partial Shading of a PV Module.
https://www.mathworks.com/help/releases/R2022a/physmod/sps/ug/partial-shading-of-a-pv-module.html

类别

在 Help Center 和 File Exchange 中查找有关 Converters (High Power) 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by