Command for Stopping the Analysis

1 次查看（过去 30 天）
Chaudhary P Patel
Chaudhary P Patel 2023-5-22
评论： Image Analyst 2023-5-26
When a variable (x) exeed the limit value (y) doing so after 5 times then stop the analysis.
  1 个评论
Dyuman Joshi
Dyuman Joshi 2023-5-22
Are you using a loop to update the variable (x) or check if x>y? If so, then you can use break.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Image Analyst
Image Analyst 2023-5-22
Try something like this
exceedCount = 0;
for k = 1 : 1000000
% First update x in the loop. Then compare it to y.
if x > y
% x is greater than y.
% Increment the count of how many times this has happened.
exceedCount = exceedCount + 1;
% Quit loop if x has exceeded y 5 times.
if exceedCount >= 5
break;
end
end
end
  7 个评论
显示 5更早的评论
Chaudhary P Patel
Chaudhary P Patel 2023-5-26
Sir @Image Analyst, for my analsis requirement i have to consider the u0<ut && u0>uc for the same loop using elseif condition.
Then where i should use the exceedCount?
Image Analyst
Image Analyst 2023-5-26
Seems inefficient, but you can do
exceedCount = 0;
for k = 1 : 1000000
% First update x in the loop. Then compare it to y.
if (u0 < ut) && (u0 > uc) % Signal is above min and below max.
% u0 is in the acceptable range.
% Do whatever.
else
% u0 is out of the acceptable range.
% Increment the count of how many times this has happened.
exceedCount = exceedCount + 1;
% Quit loop if x has exceeded y 5 times.
if exceedCount >= 5
break;
end
end
end
To learn other fundamental concepts, invest 2 hours of your time here:
MATLAB Academy - Free 2 hour training

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with MATLAB 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by