Complex Transfer Function

Question

John 2011-10-28

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/19735-complex-transfer-function

评论： Garba Elhassan 2022-1-15

I have searched around a little and can not work out how to enter a transfer function in the following form to Matlab:

G(s) = 1 / ( s*(s+0.5 +- 2j) )

Note that in the brackets it is "s plus 0.5 plus/minus 2 j' which is complex. Any assistance is appreciated.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Garba Elhassan 2022-1-15

Hello and Good day, I m working on a deadbeat controller with time delay in the plant. I was able to design a controller with the time delay into consideration.

my plant is :T_(d(z))=(0.26158 (z+11.81) (z+0.5335) (z+0.02728))/((z-1) (z^2- 0.2404z + 0.09597)) z^(-2) and

my controller is (0.2986z^4-0.07178z^3+0.02865z^2 )/(z^3+1.483z^2+0.5315z+0.01342)

the controller gives good response using the code.

The controller has more zeros than the poles.

now is the time to test in controller in Simulink, Transfer function block couldnot work, I try expressing the controller in partial fraction but two of the fraction has complex zeros and poles. I try using the block, expressing the controller using d-operators but I have z terms in the output equation.

I am realy confused on how to solve this issue.

your kind answers shall be highly appreciated.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Fangjun Jiang 2011-10-28

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/19735-complex-transfer-function#answer_26092

Take a look at the example of

doc zpk

2 个评论
显示无隐藏无

John 2011-10-29

Yes I see a similar example. However, I am not sure if the two are the same:

(i) - (s+0.5 +- 2j)

(ii) - (s+0.5 + 2j)(s+0.5 + 2j)

Thus I am not sure how to enter it in if (i) and (ii) are not the same?

Fangjun Jiang 2011-10-29

I don't understand your question. The point is to use zpk() to create the transfer function. For (i), it is zpk([],[-0.5+i,-0.5-i],1). For (ii), it is not a valid transfer function.

请先登录，再进行评论。