f28379d Motor not Spinning after deployment

9 次查看（过去 30 天）
Tarun
Tarun 2023-6-12
回答： KrishnaKumar 2025-3-5
Hi,
We are trying to run the Hub motor with Sensorsored technique along with Ti launchpad, TMS320F28379d. As per the reference, When the offset is being measured the motor is spinning. Which implies that the hall sensor and phase sequence are right. We could even measure the parameters of the motor as shown in the reference and saved the parameters for the final FOC file that had to be deployed. But when the mcb_pmsm_foc_hall_f28379d is deployed on the development board, the motor is not spinning according to the reference speed set. Is there anything that we are missing which had to be set or referred to ? What should be done to rotate the hub motor according to the reference speed.?
  1 个评论
MathWorks Motor Control Blockset Team
MathWorks Motor Control Blockset Team 2023-9-12
By implementation Hub motor with hall sensor should work.
As it involves hardware test, it is very dificult to comment without inspecting the model.
Use debug signals in the host model and monitor the signals Id, Iq and ensure they are meeting the references.
Ensure the voltage is not saturated (monitor Vd and Vq).

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

KrishnaKumar
KrishnaKumar 2025-3-5
Please follow recommendations as suggested above. Consider closing the question if it is solved or no longer relevant.

类别

在 Help Center 和 File Exchange 中查找有关 Deployment and Validation 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by