Hello, I am using ADRV9009 with Intel Arria10 SoC FPGA and want to use MATLAB on these hardware devices. I am trying to figure out on how to add new devices to the Communications Toolbox. Thanks in advance for your assistance. Regards, Ronald Victor Basil

Hardware support for MATLAB Communication Toolbox

Bharath Venkataraman 2023-6-15

Could you please clarify on what you mean by add new devices? Do you want to do FPGA in the Loop simulation, or target the devices using VHDL or Verilog code?

Ronald Basil 2023-6-15

移动：Walter Roberson 2023-6-15

Thank you for your response!

I am trying to figure out which blocks to use to be able to communicate with the adrv9009 on Arria10 SoC SPGA. Yes, FPGA in the loop simulation.

For targetting the device using Verilog Code, would it be correct if I followed the link below? https://wiki.analog.com/resources/eval/user-guides/matlab_bsp#supported_boards

Regards

YP 2023-6-15

FPGA in the Loop simulation doesn't support any kind of ADC/DAC.

I think you want blocks similar to these SDR tx/rx blocks as in

https://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/referencelist.html?type=block&s_tid=CRUX_topnav

However, we don't support SDR solution on Arria10 SoC with adrv9009.

Ronald Basil 2023-6-15

Thank you for your response!

In that case, is it possible create custom blocks?

Sincerely

fgao 2023-6-15

Hello Ronald,

SoC Blockset product can help you to create Simulink block for your custom HDL IP. You can check out this example and see if it fits your needs.

https://www.mathworks.com/help/supportpkg/xilinxsoc/ug/import-custom-hdl-ip-into-soc-blockset-design.html

Thanks,

Fei

Hardware support for MATLAB Communication Toolbox

5 个评论
显示 3更早的评论隐藏 3更早的评论

回答（0 个）

类别

产品

版本

标签

Community Treasure Hunt

Hardware support for MATLAB Communication Toolbox

5 个评论 显示 3更早的评论 隐藏 3更早的评论

回答（0 个）

类别

产品

版本

标签

另请参阅

Community Treasure Hunt

5 个评论
显示 3更早的评论隐藏 3更早的评论