get_param and set_param not running

4 次查看（过去 30 天）
Sameer Agarkar
Sameer Agarkar 2023-7-5
编辑： John D'Errico 2023-7-5
When I am trying to use get_param and set_param, sometimes it works, sometimes it doesn't, can someone tell why these irregularities are there??
  1 个评论
John D'Errico
John D'Errico 2023-7-5
编辑：John D'Errico 2023-7-5
Probable user error. Sometimes you use it properly, sometimes you don't. Yes, I did try using the mind reading toolbox, but well, sometimes it works, sometimes it does not.
If you want a better answer than that, then you need to show an example of where it does not work as you want it to work.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sanskar
Sanskar 2023-7-5
Hi Sameer!
This might be happening because sometime while running the code your model must be loaded and other times not. For get_param() and set_param() to run model must be loaded. So what you can do is load your system in the code, so that every time you run get_param and set_param, code will run smoothly.
Use following syntax
load_system(modelName)
Refer to this documentation:
Load Simulink model into memory - MATLAB load_system - MathWorks India
Hope this helps!

类别

在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by