According to the barh documentation section on Add Labels to the Ends of Bars this is supposed to work (and does work everywhere else I’ve used it), however it doesn’t work with your plot —
% Names of the Y axis ticks
names={'Feedstock cost';
'Fixed Capital Cost';
'IRR';
'Fixed Operating Cost'; 'Capacity Factor'};
% Initialize low and high matricies for speed
LCOE_low=[ 14.8, 15.627379, 15.64117003, 15.66, 18.133451];
LCOE_high=[17.77587095,16.94949315,16.96679901,16.92362191,15.06];
% The base value is where the y axis is centered
LCOE_base_value=16.29;
% Sort the values based on the lower change
% Sort the higher values and the names arrays
% using the same indices
[LCOE_low ind]=sort(LCOE_low,'descend');
LCOE_high=LCOE_high(ind);
names_LCOE=names(ind);
% Create a figure and plot the low and high horizontally
figure
h1 = barh(LCOE_low);
hold on
h2 = barh(LCOE_high,'r');
bh1 = get(h1,'BaseLine');
set(bh1,'BaseValue',LCOE_base_value);
title('Sensitivity Analysis')
set(gca,'yticklabel',names)
set(gca,'Ytick',[1:length(names)],'YTickLabel',[1:length(names)])
set(gca,'yticklabel',names_LCOE,'FontSize',12)
xlabel('LCOE ($/kWh)','FontWeight','bold')
text(h1.XEndPoints, h1.YEndPoints, string(h1.YEndPoints), 'Horiz','right', 'Vert','middle')
text(h2.XEndPoints, h2.YEndPoints, string(h2.YEndPoints), 'Horiz','left', 'Vert','middle')
% for k = 1:numel(h1.XEndPoints)
% h1.XEndPoints(k)
% text(h1.XEndPoints(k), h1.YEndPoints(k), string(h1.YEndPoints(k)), 'Horiz','right', 'Vert','middle')
% string(h1.YEndPoints(k))
% text(h2.XEndPoints(k), h2.YEndPoints(k), string(h2.YEndPoints(k)), 'Horiz','left', 'Vert','middle')
% end
I’ve tried it with and without the loop, and plotting text objects randomly on the plot, and none of them work. All the 'XEndPoint' and 'YEndPoint' references return the correct values for both bar series, so that isn’t the problem. For some reason I cannot understand, your plot simply will not work with text objects. It should.
.
