Why the PX4 firmware version supported by the Pixhawk 6x (minimum version 1.13.1) and the firmware version supported by the UAV Toolbox Support Package for PX4 Autopilots (ver

7 次查看（过去 30 天）
Guoqing
Guoqing 2023-7-6
评论： Ankur Bose 2024-3-5
My device is a Holy Pixhawk 6X, and I see in the support documentation provided by Holybro that Pixhawk 6X only supports PX4 1.13.1 and
later, but I see in MATLAB R2023a that Pixhawk 6X is now officially supported, but its PX4 version is 1.12.3. When I look in MATLAB's Hardware
setup, I found that my Pixhawk 6X's communication COM port(COM4) disappeared (this does not happen in versions after 1.13.1).
What should I do?
Please help me?
Thank you!

请先登录，再回答此问题。

回答（2 个）

Ankur Bose
Ankur Bose 2023-7-14
The support for Pixhawk 6x is available in PX4 Firmware v1.12.3. Can you elaborate on what do you mean by COM port disappears? When does this happen?
  4 个评论
显示 2更早的评论
Ahmed
Ahmed 2024-3-3
编辑：Ahmed 2024-3-3
@Ankur Bose I seem to have a similar issue with PX4 6X. The Bootloader com port , appears temporarily when we connect the Pixhawk board, and we can upload the firmware using it.
After sometimes this BOOTLOADER COM PORT disappears as intended. Then how should we commmunicate with the board as the USB Serial port does not seem to appear. (For ex: How to get gps, accel sensor data from the board). I have followed the matlab examples & documentation. There seems to be some issue with this.
If I flash PX4 versions later than v 1.13.0 through QGC, both bootloader and serial ports appear as intended and as documented by Matlab.

请先登录，再进行评论。

John conner
John conner 2024-2-22
Newer version of PX4 firmware for simulink are onther development. As i know they are working on version 1.14 for next matlab release.

类别

在 Help Center 和 File Exchange 中查找有关 PX4 Autopilots 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by