Like to have input user command for cases
显示 更早的评论
Like to ask user either enter 1,2,3 for a set of commands and then based off user unput, do a specific commands
for 1
( x=1, y=2, z=3)
for 2
(x=4, y=5, z=6)
for 3
(x=7,y=8,z=9)
then continue the code, so execute only a specific section.
Thanks.
回答（3 个）
Cris LaPierre
2023-7-10
You could use a switch-case statement
A case can be used for multiple criteria.
switch x
case {1,2,3}
%code
case {4,5,6}
%code
case {7,8,9}
%code
end
Swapnil Tatiya
2023-7-12
You could use the following code :
prompt='Enter your input';
user_input=input(prompt);
switch user_input
case{1,2,3}
%write code for what you'd like to perform
case{4,5,6}
%write code for what you'd like to perform
case{7,8,9}
%write code for what you'd like to perform
end
In the above code u can take the user_input and perform commands based on requirements
Hope this helps!
类别
在 帮助中心 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
2023-7-10
2023-7-12
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
