Speed Measurement in Torque Control

Question

adhavan d 2023-7-14

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1995953-speed-measurement-in-torque-control

评论： Sabin 2023-7-17

in Torque control IPMSM example ,I give load as Speed (rpm).Does we measure machine actual speed?.Because load speed and measured speed in ideal rotational motion sensor are same.No delta is between them.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sabin 2023-7-14

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1995953-speed-measurement-in-torque-control#answer_1273083

The load speed is the actual machine speed. By using an Ideal Angular Velocity Source, we aim to keep the machine speed constant so we can test the torque controller. It is like what is happening in a real back-to-back test rig where we have two machines, one is torque controlled and one is speed controlled. The assumption is that speed load is working perfect so we only have to worry about torque control strategy. I hope this helps.

2 个评论
显示无隐藏无

adhavan d 2023-7-17

Thanks for the answer. i am using this model to simulate the motor coupled to the vehicle environment. The vehicle control is based on torque control. I would like to understand if this method holds good to simulate the speed demand?

Sabin 2023-7-17

Yes, this is a very good way of simulating the torque control for a given speed profile.

An alternative approach would be to compute the load speed based on the vehicle dynamics and road conditions but that would slow down the simulation. An example of doing this is included in Simscape Electrical: https://www.mathworks.com/help/sps/ug/ipmsm-torque-control-in-an-axle-drive-ev.html

请先登录，再进行评论。