清空筛选条件
清空筛选条件

how to model an air turbine start system in Simulink?

7 次查看（过去 30 天）
Vincent Susai
Vincent Susai 2023-7-26
回答： MathWorks Simscape Team 2023-7-31
I have planed to simulate a pneumatic Air Turbine Starter system in Simulink but I don't know to simulate a pneumatic Air Turbine Starter system with Simulink? Could you please help me about this issue?
Source of air is from Load compressor.
Air Mass Flow Rate = 70 kg/min
Air Prressire = 40 psi
Torque Out Put = 1440 N-m

请先登录，再回答此问题。

回答（1 个）

MathWorks Simscape Team
Hi Vincent,
You should start by doing the Simscape Onramp to learn the basics of Simscape.
Then, if you look at these examples, you will see many of the components you will need
https://www.mathworks.com/help/sps/ug/wind-turbine.html
https://www.mathworks.com/help/simscape/ug/brayton-cycle-gas-turbine-with-custom-components.html
I recognize these are not an exact match to the type of turbine you are modeling, but it shows how to use many of the components you will need.
--Steve

类别

在 Help Center 和 File Exchange 中查找有关 Engines & Motors 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by