F28388D, IPC, and Flash Boot

4 次查看（过去 30 天）
Yo-An Lim
Yo-An Lim 2023-8-8
回答： Ganesh Thambhahalli Satyen 2023-9-4
I'm using R2023a, C2000 microcontroller blockset, embedded coder, and F28388D.
Below is for CPU1 and the GPIO is for an LED indication. Also for clarification, I'm using an example program of the C2000 microcontroller blockset.
And below is for CPU2.
Boot options like the pin positions and the setting in Configuration Parameters are set correctly.
Then, I downloaded the above programs to CPU1 and CPU2 using the CCS and a JTAG programmer, and started the programs on the CCS.
And everything worked very well as expected.
But, I encountered a problem just after I turned OFF and ON again the MCU power. I couldn't see any LED blinking, which said the MCU was not working.
I repeated above procedures, but in this case I removed all the IPC blocks. Then it worked very well, even after the power switching.
I used the same MCU and IPC blocks(embedded coder support package) in R2022a version before without any problem.
Could anybody give me some help?
  1 个评论
Thierry Daras
Thierry Daras 2023-8-21
Hi,
I have the same problem with R2023a .
Could you have any answer for this question?
Best regards.
TD.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Ganesh Thambhahalli Satyen
Hi Yo-An,
I understand that you are facing an issue after you power cycle your hardware board.
This is a bug which has been fixed in MATLAB R2023a Update 5. The following external bug report gives the procedure to fix this:
https://www.mathworks.com/support/bugreports/details/3027690
Regards,
Ganesh Thambhahalli Satyen

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by