How-To install gcc-8 in Debian 10 (bullseye) for Matlab R2020b?
13 次查看(过去 30 天)
显示 更早的评论
As Debian 10 comes with gcc-10, I cannot mex c-files here, as Matlab says gcc-10 is too new.
R2020b's gcc version is gcc-8. I tried to install it but did't get far...
Please Help
0 个评论
回答(2 个)
Andreas Goser
2023-8-11
Just to to make sure you have seen the R2020b system requirements and supported compilers, I have linked them here.
In essence, you attempt to run a supported environement and are also correct abput GCC 10 being not supported.
The question now is what "but did't get far..." excactly means. Where are you stuck? Is there an error message?
0 个评论
Timo Dörsam
2023-8-11
2 个评论
Andreas Goser
2023-8-11
OK, got it. So then we need to see if there are knowlesbale people in the community about this. When I ran a Google search "gcc 8 on debian 10", this thread is number 6, which makes me believe this is not a frequent issue.
Have you considered installing a more recent MATLAB release? You may say all your project partners agreed on using R2020b, but you could give it a try. One great aspect of MathWorks products is you can install multiple release in parallel.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!