Conducting Radar Maritime Reflectivity

Question

I.Osman 2023-8-20

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2010572-conducting-radar-maritime-reflectivity

回答： Sara James 2024-8-6

% Analyze for sea states 1 through 5 ss = 1:5; % Sea states

% Initialize outputs numSeaStates = numel(ss); hgtsd = zeros(1,numSeaStates); beta0 = zeros(1,numSeaStates); vw= zeros(1,numSeaStates);

% Obtain sea state properties for is = 1:numSeaStates [hgtsd(is),beta0(is),vw(is)] = searoughness(ss(is)); end

% Plot results helperPlotSeaRoughness(ss,hgtsd,beta0,vw);

4 个评论
显示 2更早的评论隐藏 2更早的评论

I.Osman 2023-8-20

The code doesn't working

Dyuman Joshi 2023-8-20

编辑：Dyuman Joshi 2023-8-20

How is it not working? What are you trying to do?

Do you have the Radar toolbox that is required to run searoughness? What is helperPlotSeaRoughness()?

You have to specify things, as the mind reading toolbox has not been released yet.

Go through the link @Image Analyst has mentioned in their comment and edit your question accordingly.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sara James 2024-8-6

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2010572-conducting-radar-maritime-reflectivity#answer_1495436

在 MATLAB Online 中打开

First, the above code requires Radar Toolbox to use the searoughness function.

The helperPlotSeaRoughness is not a documented Radar Toolbox function. It was a helper specifically created for the Maritime Radar Sea Clutter Modeling example. If you would like to use this function elsewhere, you can save off the local function from the example livescript into its own file. The code for the helper from that example is below.

function helperPlotSeaRoughness(ss,hgtsd,beta0,vw)
% Creates 3x1 plot of sea roughness outputs 
% Create figure
figure
% Plot standard deviation of sea wave height
subplot(3,1,1)
plot(ss,hgtsd,'-o','LineWidth',1.5)
ylabel([sprintf('Wave\nHeight ') '\sigma_h (m)'])
title('Sea Wave Roughness')
grid on; 
% Plot sea wave slope
subplot(3,1,2)
plot(ss,beta0,'-o','LineWidth',1.5)
ylabel([sprintf('Wave\nSlope ') '\beta_0 (deg)'])
grid on; 
% Plot wind velocity 
subplot(3,1,3)
plot(ss,vw,'-o','LineWidth',1.5)
xlabel('Sea State')
ylabel([sprintf('Wind\nVelocity ')  'v_w (m/s)'])
grid on; 
end