How to change block sample time using a trigger

4 次查看（过去 30 天）
Thomas
Thomas 2023-8-30
评论： Thomas 2023-8-30
Could someone point me in the direction of which block I need to to use?
I have my Simulink model running at a fixed TimeStep of 0.001s. I have successfully created a TCP link using the TCP Client and TCP Send blocks. I do not want to pass the data to the TCP Send block every 0.001s, I only want to the pass the data to the TCP Send block when there is a trigger signal. The attached image shows what I would like to do:
I have tried the enabled/triggered subsystems but the output sample rate is the same as the input sample rate, i.e. 0.001s. For information, I am using Real-Time Simulation.
Is there any Simulink block that will change the output sample rate based on a trigger?

请先登录，再回答此问题。

采纳的回答

Dimitri MANKOV
Dimitri MANKOV 2023-8-30
Hi Thomas,
I would simply move the TCP Send block inside of the triggered / enabled subsystem, this should do the trick :)
Best,
Dimitri

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Development Computer Setup 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by