Hi Jongwon Lee,
I understood that you’re looking for multiple GPS connectivity to the cube orange board, The use of multiple GPS units with PX4 and MATLAB is indeed possible, but there are a few things to consider.
Firstly, the GPS module is enabled by default in the startup script (“rc.txt”) available with UAV Toolbox Support Package for PX4 Autopilots. In this startup script, only the main GPS device is enabled on the port ‘/dev/ttyS3’. To enable main GPS on a different serial port or to enable secondary GPS, you would need to modify the “rc.txt” manually.
Secondly, when it comes to blending or using multiple GPS units, it’s usually recommended to use two GPS units from the same manufacturer because the scaling of the accuracy numbers varies and will lead to favouring one GPS over the other.
In addition, based on the PX4 documentation you provided, it seems that there are specific parameters for enabling UAVCAN subscriptions such as “UAVCAN_SUB_GPS” for GPS. A system reboot is required after changing this parameter. However, please note that these settings are specific to the PX4 firmware.
Also, please note that if you’re using the PX4 CAN transmit and receive block from the UAV Toolbox Support Package for PX4 Autopilots, you should disable UAVCAN before working with PX4 CAN blocks by setting the PX4 parameter, “UAVCAN_ENABLE” to 0. Unfortunately, CAN blocks are not supported on “STM32H7” based autopilots (Cube Orange and Pixhawk 6x).
for reading GPS data from PX4 autopilot please refer to Reading GPS Data from PX4 Autopilot - MATLAB & Simulink Example - MathWorks India, to read more about PX4 CAN receive followed by transmit please refer to Receive message from CAN network - Simulink - MathWorks India and for UAVCAN_SUB_GPS please refer to Parameter Reference | PX4 User Guide
Best regards,
Uday
