Two surf plots in the same figure
显示 更早的评论
When trying to plot two surf plots in the same figure, surf plots are not displaying. The problem seems as if the axes limits are not getting updated as per the set values. Kindly help me to solve this problem. The following is the code.
figure;
ax = gca;
ax.XLimMode = 'manual';
xlim([-10000 10000]);
ylim([-10000 10000]);
zlim([-10000 10000]);
ra = 0.5;
r1 = [4.662840968803412 -0.597125750259697 -5.446916224720714]*10^03;
r2 = [0.662840968803412 -4.597125750259697 -5.446916224720714]*10^03;
[X1 Y1 Z1] = ellipsoid(r1(1),r1(2),r1(3),ra,ra,ra);
[X2 Y2 Z2] = ellipsoid(r2(1),r2(2),r2(3),ra,ra,ra);
surf(X1,Y1,Z1); hold on;
plot3(r2(1),r2(2),r2(3),'*m'); hold on;
surf(X2,Y2,Z2);
采纳的回答
"seems as if the axes limits are not getting updated as per the set values"
Set the axes limits after plotting:
figure;
ra = 0.5;
r1 = [4.662840968803412 -0.597125750259697 -5.446916224720714]*10^03;
r2 = [0.662840968803412 -4.597125750259697 -5.446916224720714]*10^03;
[X1 Y1 Z1] = ellipsoid(r1(1),r1(2),r1(3),ra,ra,ra);
[X2 Y2 Z2] = ellipsoid(r2(1),r2(2),r2(3),ra,ra,ra);
surf(X1,Y1,Z1); hold on;
plot3(r2(1),r2(2),r2(3),'*m');
surf(X2,Y2,Z2);
xlim([-10000 10000]);
ylim([-10000 10000]);
zlim([-10000 10000]);
Note that the axes limits are correct, but you don't see the ellipsoids because they are so small (radius = 0.5; axes-limits = [-10000 10000]). If you were to increase their radius, you'd see them:
figure;
ra = 5000;
r1 = [4.662840968803412 -0.597125750259697 -5.446916224720714]*10^03;
r2 = [0.662840968803412 -4.597125750259697 -5.446916224720714]*10^03;
[X1 Y1 Z1] = ellipsoid(r1(1),r1(2),r1(3),ra,ra,ra);
[X2 Y2 Z2] = ellipsoid(r2(1),r2(2),r2(3),ra,ra,ra);
surf(X1,Y1,Z1); hold on;
plot3(r2(1),r2(2),r2(3),'*m');
surf(X2,Y2,Z2);
xlim([-10000 10000]);
ylim([-10000 10000]);
zlim([-10000 10000]);
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Graphics Object Properties 的更多信息
Translated by 
