Dimensional analysis fail for reaction on simbiology

1 次查看（过去 30 天）
Lo
Lo 2023-9-4
回答： Arthur Goldsipe 2023-9-18
I have already tried adjusting the units of the reactants and parameters, but I still receive an error message. I'm not sure where the issue is.
  3 个评论
显示 1更早的评论
Lo
Lo 2023-9-4
编辑：Lo 2023-9-4
hi Arthur Goldsipe
I attempted to simulate recombinase polymerase amplification, and I have already found the necessary ODEs for simulation.
here is the diagram
here is the reactant's dosage and unit
here is the parameter's unit
here is the ODEs
Jeremy Huard
Jeremy Huard 2023-9-4
The first term of the rate rule in the first screenshot you sent (or rate rule #2 in your second post) is not dimensionally consistent with the left-hand side.
You get molarity/time=mole/volume/time for the left-hand side and for the term of the right-hand side:
(dimensionless/dimensionless) * (1/(molarity*time)) * mole * molarity = mole/time

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Arthur Goldsipe
Arthur Goldsipe 2023-9-18
It looks like this was answered in a comment on the question. I'll paste it here for completeness:
The first term of the rate rule in the first screenshot you sent (or rate rule #2 in your second post) is not dimensionally consistent with the left-hand side.
You get molarity/time=mole/volume/time for the left-hand side and for the term of the right-hand side:
(dimensionless/dimensionless) * (1/(molarity*time)) * mole * molarity = mole/time

社区

更多回答在  SimBiology Community

类别

在 Help Center 和 File Exchange 中查找有关 Perform Sensitivity Analysis 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by