Unstable LPF filter response in Simulink

2 次查看（过去 30 天）
Egor Losev
Egor Losev 2023-9-11
编辑： Egor Losev 2023-9-11
Hello,
I'm trying to simulate an RF system. I have an analog sinewave carrier at 700 MHz which has analog sinewave phase modulation at 700kHz:
Fs = 100e9; % Sampling rate
Fc = 700e6; % Carrier frequency in Hz
t = (0:1/Fs:0.000004)'; % Time points for sampling
f = 0.7e6;
phi = 0.0025*sin(2*pi*f*t);
y = sin(2*pi*Fc*t+phi);
y = [t, y];
This signal then goes through this system:
The idea is to demodulate this signal into I and Q streams, digitize them with a 12 bit adc with 100 MHz clock (here I just downsample the signal simulating a FIR compiler) low pass filter the I and Q streams and then calculate the phase modulation with an atan2.
My problem is that up to the LPF everything works fine, from Fs = 100e9 I downsample to Fs = 100e6, and before the LPF the I stream is modulated with the imposed modulating signal (bottom left square):
However, at the output of a low pass filter (upper right square) I get a signal with a huge amplitude swings, which causes the atan2 to go crazy. What am I doing wrong?
There's nothing special in the filter parameters which would cause it to be unstable:

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Analog Filters 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by