problem with transmission block simscape

2 次查看（过去 30 天）
DAVIDE DE BATTISTI
DAVIDE DE BATTISTI 2023-10-1
编辑： Akshat 2023-10-3
Hello, I'm modelling a vehicle transmission with the block "transmission" that you can find in simscape. It's an 8 speed transmission, I set the logic to change gear, but the vehicle stops at 2 km/h. If I use a simple gear with a certain gear ratio it works. If i keep the transmission connected and i increase by 100 times the inertia of the engine it slowly accelerate. what I should check, is there a recent example where the transmission block is used? thank you

请先登录，再回答此问题。

回答（1 个）

Akshat
Akshat 2023-10-2
编辑：Akshat 2023-10-3
Hi @DAVIDE DE BATTISTI
I understand that you are facing issues while leveraging the 'transmission' block in Simscape. Since your focus is on 8-speed transmission, the following references could provide valuable insights and assist you in resolving the issue.
https://in.mathworks.com/help/sdl/ref/8speed.html
https://in.mathworks.com/help/sdl/ug/transmission-testbed.html
I hope this helps.

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Driveline 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by