How to specify serverID when using modbus for Raspberry Pi?

Question

KristianT 2023-10-2

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2028244-how-to-specify-serverid-when-using-modbus-for-raspberry-pi

回答： Rijuta 2023-10-13

Hi!

I have a Raspberry Pi that is running a modbus server. In Matlab I can easily communicating with the server by using the Industrial Communication Toolbox:

m = modbus('tcpip', '192.168.XX.XX', 502)

read(m,'holdingregs',49+1,7, 1)

Where the last input to the read function is the serverID.

My problem is that when I try to do the same thing using the modbus blocks in ther Raspberry Pi support package for Simulink there is no obvious way for how I can specify the serverID. Does anyone know how I can specify the serverID when using the modbus communication block in Simulink for Raspberry Pi?

Thanks!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Rijuta 2023-10-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2028244-how-to-specify-serverid-when-using-modbus-for-raspberry-pi#answer_1332234

Hi Kristian,

I understand that you want to specify the server ID of a Modbus communication block in Simulink for Raspberry Pi.

In Modbus communication, the server ID is essentially the address of the server to send the read command to. Simulink Support Package for Raspberry Pi Hardware supports the Modbus communication protocol over the TCP/IP network with the following blocks:

‘Modbus TCP/IP Client Read’: https://www.mathworks.com/help/supportpkg/raspberrypi/ref/modbustcpipclientread.html?s_tid=doc_ta
‘Modbus TCP/IP Client Write’: https://www.mathworks.com/help/supportpkg/raspberrypi/ref/modbustcpipclientwrite.html?s_tid=doc_ta#mw_47bfb4d1-3a0d-4ba3-9d91-4437214e44c7

Both these blocks provide ‘Server address’ as a parameter which allows you to enter the IP address of the server device to identify the server from which the client reads the data or to which the client writes the data. The default value of the Server address is 127. You can double click on the block to modify this value.

I hope this solves your query.