Build, Deploy & Start not working

Question

0 个投票

Attempting to deploy my application for the Zynq MPSoC ZCU102 radio platform, and when I click build, deploy and start on my interface model, it only builds but never attempts to deploy the application.

Reference guide:

https://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/ug/hw-sw-co-design-qpsk-transmit-and-receive-using-analog-devices-ad9361-ad9364.html

Diagnostic viewer ends at:

Build process completed successfully

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

Answer 1

akshatsood 2023-10-14

编辑：akshatsood 2023-10-14

0 个投票

Hi Paul,

I understand that you seek guidance on deploying your application on the Zynq MPSoC ZCU102 Radio Platform. To assist you, I recommend referring to an article prepared by the MathWorks Support Team. This article provides comprehensive steps for deploying your application in a standalone mode on Zynq MPSoC ZCU102 Radio Platform.

https://in.mathworks.com/matlabcentral/answers/474175-how-do-i-deploy-an-arm-software-executable-from-a-simulink-model-to-my-zynq-board-to-run-in-standalo

If you encounter any connection issues, I suggest referring to the following reference for troubleshooting steps.

https://in.mathworks.com/matlabcentral/answers/408583-troubleshooting-connection-issues-with-xilinx-zynq-platform?s_tid=srchtitle

I hope this helps.