plotting PPG signal using PWL source

Question

abd-elRaoof 2023-10-17

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2034589-plotting-ppg-signal-using-pwl-source

编辑： Prasanna 2024-10-21

hello sir ,

i want to plot PPG signal .csv or xlsx file using PWL source to plot ,

i have imported the datasheet to the editor ,how can we make variables that can be seen by simulink , PWL source ??
COULD the PWL source accept variables ?

i bulit the circiut consisting of : (PWL source - voltage sensor - PS simulink - scope ) to show the waveforn but it doesn't work -need solver config-

is there any another solution ??

excue me for my weak english

thanks

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

abd-elRaoof 2023-10-17

ONline matlab version

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Prasanna 2024-10-21

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2034589-plotting-ppg-signal-using-pwl-source#answer_1534650

编辑：Prasanna 2024-10-21

在 MATLAB Online 中打开

Hi abd-elRaoof,

To plot a PPG signal from a source file using a piecewise linear (PWL) source in Simulink, you can do the following steps:

Load the PPG signal data file into MATLAB using ‘readmatrix’ and extract the corresponding time and signal values from the data.
After preparing the data for PWL source where the first column is time and second column is the signal value, configure the PWL source in Simulink and set the PWL vector of time-value pairs parameter to the PWL data.
Add a solver configuration block, connect the PWL source to the rest of the circuit and run the simulation to visualize the PPG result.

A sample code assuming the data is present in a file named ‘data.csv’ with the first column as time and second column as signal and a Simulink model with the name ‘sim_model’ is given below:

% Load data 
data = readmatrix('data.csv');  
time = data(:, 1); 
signal = data(:, 2); 
% Prepare PWL data 
pwl_data = [time, signal]; 
% Open Simulink model 
open_system('sim_model'); 
% Set PWL Source data 
set_param('sim_model/PWL Source', 'PWLVector', 'pwl_data'); 
% Run the simulation 
sim('sim_model'); 

Some other points you can check if the waveform doesn’t show is to check the solver configuration connections and making sure that the ‘pwl_data’ variable is in the MATLAB workspace when running the Simulink model. If the PWL source is problematic, consider using a ‘From Workspace’ block to import data directly into Simulink. For more information on the functions used, refer the following documentations: