Can we use control system toolbox apps on simscape components

3 次查看（过去 30 天）
Gopal Krishnan
Gopal Krishnan 2023-10-29
回答： Sabin 2023-11-1
I have made a motor drive with inverter. Now to design a PI controller using control system toolbox apps I am facing issues. Kindly help.
  1 个评论
Sam Chak
Sam Chak 2023-10-29
@Gopal Krishnan, it is rather difficult. Perhaps you expect a general 'Yes' or 'No' answer. If we switch roles, then you'd probably understand. For example, assuming that you are an inverter expert, how would you help me if I told you that I'm facing only one specific technical issue in the motor design?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2023-11-1
A good starting point is the Tune Field-Oriented Controllers for a PMSM Using Closed-Loop PID Autotuner Block example in Simulink Control Design. This example shows how to tune a field-oriented controller for a PMSM-based electrical-traction drive (implemented in Simscape Electrical) in just one simulation using the Closed-Loop PID Autotuner block.

类别

在 Help Center 和 File Exchange 中查找有关 Real-Time PID Autotuning 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by