Seeking help on real time signal monitoring using XCP on Ethernet (TCP/IP and UDP/IP) and C2000 (F28388) Microncontroller

3 次查看（过去 30 天）

ismail hossain 2023-11-5

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2043272-seeking-help-on-real-time-signal-monitoring-using-xcp-on-ethernet-tcp-ip-and-udp-ip-and-c2000-f28

Dear Community

Greetings!

I want to develop a model based three phase inverter control using Matlab Simulink and TI F28388 control card.

For the following circuit, I want to monitor 3-phase grid voltage, 3-phase grid current and DC side DC link voltage and current in Real time.

Usually, the signal frequency is maximum 120 Hz and the number of signals are 8 (3+3+2).

As you see the number of signals are pretty high but frequency low, I want to use XCP on Ethernet (TCP/IP and UDP/IP) as shown in the following figure. I have access to all Adds ON in Matlab.

Could you please guide me the best possible way to do that using XCP or other interface?

Any possible example or details guideline are highly appreciated.

Is it possible to monitor such number of signals in real time and tune the other variables ?

What are the maximum number of signals that can be monitored in real time on Matlab Simulink using Ethernet (TCP/IP and UDP/IP). The ethernet port of F28388 control card can handle upto 10/100 Mbps.

I will use external oscilloscope for PWM signal monitoring as frequency is very high (20kHz).

However, I want to monitor low frequency signals (60/120 Hz) like 3-phase grid voltage, 3-phase grid current and DC side DC link voltage and current in Real time.

Thanks

Ismail