Seeking help Parameter Tuning and Signal Logging with Serial Communication with C2000

1 次查看（过去 30 天）
ismail hossain
ismail hossain 2023-11-11
Dear Community
I am trying to practice example "Signal Logging and Parameter Tuning in XCP External Mode with Packed Mode" based on F28379D hardware . I want to use serial over USB for Parameter Tuning and Signal Logging with Serial Communication.
According to the following statement"
The default baud rate is 115200. You can increase the baud of the serial over USB of your Launchpad or controlCARD. On Launchpads and controlCARDs using FTDI 2232H, you can select any baud less than or equal to 6 Mbps, or exactly 9 or 12 Mbps. On controlCARDs using FTDI 2232D, you can select any baud less than or equal to 1.5 Mbps, or exactly 2 or 3 Mbps. So my board has FTDI 2232H, which support upto 12Mbps.
In SCI_A setting, it is fine to set baudrate 12Mbps.
However, in computer com port setting (The connected F28379D launchpad port), I found maximum baudrate 921600 bps, which is far less than 12 Mbps.
Therefor, How can I make both settings at the the same baudrate?
Please help.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Signal Monitoring and Parameter Tuning 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by