Error with running a Simulink model.

21 次查看（过去 30 天）
Sam
Sam 2023-11-17
评论： Sabin 2023-11-21
I have a run file to run the fowards facing model of this electric motor and this is whats happens...
Every time I run the forwards model matlab run file and then go on my backwards model and run it I get these 4 errors. But if I don’t run the run file and then run the backwards model straight away, it works every time with no errors and the correct outputs.Any ideas?

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2023-11-20
Without the files is not easy to tell where the problem is. I suspect when you run the first model some parameters from the workspace are either overwritten or deleted from workspace which will result in the errors when running the second model. First, I would check all callbacks and the names used for data logging. I hope this helps.
  3 个评论
显示 1更早的评论
Sam
Sam 2023-11-21
So i created a new model and put a sine wave block in the used a to workspace block to see if it was my simulink model. It still didn't put that variable in my workspace. Is there a setting that i may have changed to stop variables going into my workspace?
Sabin
Sabin 2023-11-21
May be that 'Single simulation output' is enabled in the Configuration Parameters. If that's the case the data is saved as 'out' (or a different name if changed) in the workspace.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by