How to deploy code to custom STM32 board via ST-Link JTAG?

15 次查看（过去 30 天）
Tanmay Bhatia
Tanmay Bhatia 2024-1-19
回答： Debadipto 2024-2-6
STM32 cube programmer connects to the Custom MCU fine but Matlab gives error "no STM32 MCU connected". I am not deploying the code using serial directly but rather using ST link JTAG (5 pin). Please advise with correct parameters.
I was following the tutorial by Matlab: https://au.mathworks.com/videos/using-simulink-with-stm32-discovery-and-stm32f4xx-based-boards-1637578171735.html
Thank you.

请先登录，再回答此问题。

回答（1 个）

Debadipto
Debadipto 2024-2-6
Hello @Tanmay,
I understand that you are getting the error 'No STM32 MCU connected' during the deployment.
STM32CUBEMX is related to a third-party tool controlled by STMicroelectronics. You can leverage help from the ST community by posting your query on the “Ask” section of their website.
Please refer to the following link to the ST Community page - https://community.st.com/s/

类别

在 Help Center 和 File Exchange 中查找有关 STMicroelectronics Discovery Boards 的更多信息

标签

产品


版本

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by