Gettting an error when trying to run the "Exchanging WiFi Data and Using ThingSpeak with STM32L475VG Discovery Board" MatLab example

1 次查看（过去 30 天）
Carleene Morien
Carleene Morien 2024-2-1
回答： Madhu Varshini 2024-2-12
When running this example, the step where it is Run Host Model to Receive and Analyze Data in Task 1, the host model when ran gives me the following error.
I double checked the port and address and they are the same as the Local IP port of the WiFi send and recieve block on the target model. I am using a static IP address for the target hardware and set the remote address parameters of the host model TCP send and recieve blocks to that address.

请先登录，再回答此问题。

回答（1 个）

Madhu Varshini
Madhu Varshini 2024-2-12
Hi , I tried running the example at my end. It works fine without any error.
Make sure the wifi setup and configuration parameter in WiFi is properly set.
If you are unable to resolve the issue, please reach out to Technical Support with model and reproduction steps.

类别

在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by