How to disable Code generation in Simulink altogether?

6 次查看（过去 30 天）
RAGHUVEER RAJESH
RAGHUVEER RAJESH 2024-2-12
评论： RAGHUVEER RAJESH 2024-2-15
I am injecting faults through Fault Models. Fault models dont support code generation. Therefore, I am getting an eeror while running the simulation.
=== Simulation (Elapsed: 14 sec) ===
Error:Unable to simulate, generate code, or perform Simulink Design Verifier Analysis for model 'ConfiguredVirtualVehicleModel'. Only normal mode simulation is supported for fault models, models that have fault simulation enabled, or conditionals mapped to Simulink signals.
How can I disable autocode generation and just keep simulation running in Simulink?
  2 个评论
Harald
Harald 2024-2-12
Hi Raghuveer,
any objections against switching to normal mode as the error suggests?
Best wishes,
Harald
RAGHUVEER RAJESH
RAGHUVEER RAJESH 2024-2-15
Switching back to Normal mode worked!! Thank you very much... Querry Solved!!.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Pulse width modulation (PWM) 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by