How to disable Code generation in Simulink altogether?
7 次查看(过去 30 天)
显示 更早的评论
I am injecting faults through Fault Models. Fault models dont support code generation. Therefore, I am getting an eeror while running the simulation.
=== Simulation (Elapsed: 14 sec) ===
Error:Unable to simulate, generate code, or perform Simulink Design Verifier Analysis for model 'ConfiguredVirtualVehicleModel'. Only normal mode simulation is supported for fault models, models that have fault simulation enabled, or conditionals mapped to Simulink signals.
How can I disable autocode generation and just keep simulation running in Simulink?
2 个评论
Harald
2024-2-12
Hi Raghuveer,
any objections against switching to normal mode as the error suggests?
Best wishes,
Harald
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Prepare Model Inputs and Outputs 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!