Hello Madhurjya,
To simulate continuous 5G signal generation in MATLAB, you can use a loop to repeatedly call the nrWaveformGenerator function. Here's a concise guide:
- Set simulation parameters: Choose your simulation duration and signal parameters (e.g., subcarrier spacing, bandwidth).
- Initialize configurations: Before the loop, set up your carrier, UE, and channel configurations.
- Implement a loop: Use a loop to generate waveforms at each time step for the entire simulation duration.
- Generate and process waveforms: Inside the loop, call nrWaveformGenerator to create your signal, then analyze or store it as needed.
- Post-processing: After the loop, perform any final analysis on the collected data.
Here is a pseudo code for your reference:
% Define simulation duration and time step
simulationDuration = 10; % seconds
timeStep = 1e-3; % seconds
numSteps = simulationDuration / timeStep;
% Initialize 5G configurations
% ...
% Simulation loop
for step = 1:numSteps
% Generate the 5G waveform
[waveform, ~, ~] = nrWaveformGenerator(...); // Remember to replace ... with your actual parameters
% Analyze or store the waveform
% ...
end
% Post-process the data
% ...
I hope it helps.
Best Regards,
Asim Asrar
