@Marvin Hope this is what you want:
% Check for Antenna Toolbox availability
if ~license('test', 'Antenna_Toolbox')
error('Antenna Toolbox is not available. Please install it to run this example.');
end
% Define the operating frequency
freq = 300e6; % 300 MHz
% Create the first Yagi-Uda antenna
yagi1 = design(yagiUda, freq);
% To rotate the second Yagi-Uda antenna, we first create it
yagi2 = design(yagiUda, freq);
% Apply rotation
yagi2.Tilt = 90;
yagi2.TiltAxis = [0, 0, 1]; % Rotate around the Z-axis
% Visualize the first Yagi-Uda antenna
figure;
show(yagi1);
title('Yagi-Uda Antenna 1');
% Visualize the second Yagi-Uda antenna (rotated)
figure;
show(yagi2);
title('Yagi-Uda Antenna 2 (Rotated)');
% For analysis or simulation, create a conformalArray with both antennas
% Note: The positions and orientations must be carefully set for accurate modeling
conformalArray = conformalArray('Element', {yagi1, yagi2}, 'ElementPosition', [0 0 0; 0 0 0], 'Tilt', [0, 90], 'TiltAxis', repmat([0 0 1], 2, 1));
% Visualize the conformal array
figure;
show(conformalArray);
title('Conformal Array of Combined Yagi-Uda Antennas');
-----------------------------------------------------------------------------------------------------------------------------------------------------
If you find the solution helpful and it resolves your issue, it would be greatly appreciated if you could accept the answer. Also, leaving an upvote and a comment are also wonderful ways to provide feedback.
It's important to note that the advice and code are based on limited information and meant for educational purposes. Users should verify and adapt the code to their specific needs, ensuring compatibility and adherence to ethical standards.
Professional Interests
- Technical Services and Consulting
- Embedded Systems | Firmware Developement | Simulations
- Electrical and Electronics Engineering
Feel free to contact me.
