Hello All, I am trying to implement a pulse counter on a RasPi 3 Model B using Simulink and send the count to ThingSpeak cloud using the ThingSpeak Write block.

1 次查看（过去 30 天）

Krishna Ghanakota 2024-3-9

I have implemented the functionality using a polling mechanism (Model_02) and it works fine.

The model counts an edge rise on GPIO 20 and writes GPIO 21 with the value from GPIO 20.

Every minute the aggregated pulses are pushed to cloud using ThingSpeak write.

However, when I try to implement the same functionality using interrupts (Model_10) the model fails to run on the hardware.

I have narrowed down the problem to the ThingSpeak write block. Commenting this block runs the code on the hardware.

The red bounding box shows the functionality inside the function call subsystem.

I am attaching Model_02 and Model_10 for reference.

Any help as to why Model_10 fails to run is greatly appreciated.

Thank you.

Test and Measurement ThingSpeak

在 Help Center 和 File Exchange 中查找有关 ThingSpeak 的更多信息

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by