Unable to use Simulink's acceleration mode

2 次查看（过去 30 天）
鹏政
鹏政 2024-3-19
编辑： Debadipto 2024-3-28
In MATLAB/Simulink, when running simulation files of the same version copied from other devices in acceleration mode, the simulation can only be run when it is not changed for the first time. However, when some parameters in the model are changed, an error is reported when simulating again, which is a problem when creating an acceleration MEX file for model 'xxxxxxx'. To view the compiled output, use set_param ('xxxxxxx ',' AccelVerboseBuild ',' on ')

请先登录，再回答此问题。

回答（1 个）

Debadipto
Debadipto 2024-3-28
编辑：Debadipto 2024-3-28
Hi @鹏政,
The MATLAB answer linked below outlines several potential causes for the error you're facing:
https://www.mathworks.com/matlabcentral/answers/814790-why-do-i-get-the-build-error-no-rule-to-make-target
Based on the screenshots, it seems like the issue might be related to point (3) from the post, where a lengthy directory path name leads to the 'gmake' error. To resolve this problem, you can try shortening the path name as indicated in the aforementioned link.
Hope this helps!

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by